PM^{EQUIPMENT CO.}

14525 Ravenna Road   *  Newbury , Ohio 44065

Phone# (440) 564-2219  *  Fax# (440) 564-9896

Website:  www.pmequipment.com *  Email:  sales@pmequipment.com

Click the logo to visit their website.

Wendland Manufacturing created this catalog to assist the representative, architect, engineer or designer in selecting tanks for his/her needs. This catalog outlines only a few of the many standard tanks that we fabricate. Our standard vessel sizes are shown in table format for your convenience. The standard drawings are for customer convenience and should be used as a guide only. If you require, we can custom fabricate a vessel to your particular specifications and provide you with a custom drawing to your specifications. Wendland fabricates vessels to specifications of the two most commonly used tank standards. We fabricate A.S.M.E. Code vessels to requirements of Section VIII, Division 1. In addition, we fabricate UL specification #142 for above ground installation. Also available is our standard noncode pressure tank built to your specifications. Wendland’s modern production facilities enable us to build a wide range of vessels. We can fabricate tanks from 10-gallon capacity to 50,000-gallon capacity or from one tank to any quantity you require. We have made a commitment to make the highest quality vessel available at an economical price and to give you the best service available in the industry. If required, Wendland will make every effort to assist you in formulating and writing a specification to meet your specific tank needs.

Key Benefits

• A.S.M.E. Code Tanks & National Board Registration

  The American Society of Mechanical Engineers was established with the objective of formulating rules for fabricating pressure vessels, to afford reasonably certain protection of life and property and to provide a margin for deterioration in service so as to give a reasonably long period of safe usefulness. The A.S.M.E. Code governs the design material, fabrication, and quality control via an outside authorized inspection agency that oversees the A.S.M.E. Code vessel from start to completion by inspecting all processes. All Wendland Mfg. A.S.M.E. Code tanks are built in strict compliance to meet or exceed the A.S.M.E. Section VIII, Division 1 Code requirements. The tanks will be furnished with an A.S.M.E. Code nameplate, and we can furnish the customer with manufacturer’s data report verifying A.S.M.E. Code compliance. We can also register the tanks with the National Board of Boiler & Pressure Vessels if required. 

• Wendland Standard Pressure Tanks

  When the A.S.M.E. Code stamp is not required, Wendland can furnish a standard pressure tank of high quality built to your specifications. These tanks have sufficient safety factors and are hydrostatically tested at one and one half times the design pressure. Since these tanks are fabricated by the same personnel as the A.S.M.E. tanks, you can be assured that these vessels are built with the same welding procedures and meet A.S.M.E. Code quality. As a result of this, you will have a high quality tank at a more economical price than vessels built with the A.S.M.E. Code symbol. Wendland can also furnish you with a standard non-code pressure tank. These tanks also have sufficient safety factors and are air tested. These vessels are a quality tank at an economical price.

• U L Storage Tanks

We also offer a U.L. labeled fuel storage tank, which is required by fire marshals of most municipalities. Underwriters Laboratories is an independent non-profit organization testing for public safety. This organization regulates material thickness, joint procedures and overall vessel design. We offer aboveground fuel  storage tanks fabricated to U.L. specification #142. Our U.L. tanks are built under strict adherence to our Quality Control Department and meet all U.L. directives. Each U.L. tank is thoroughly inspected and tested prior to shipment. These tanks are intended for installation and use in accordance with NFPA30 and NFPA31 requirements of the National Fire Protection Association.

Specification Guide and Table